C
HAPTER
15
| Security Commands
Privilege Level Configuration
– 313 –
DEFAULT SETTING
There is one default user account which is assigned the user name “admin”
and has no password. The privilege level for this account is 15.
EXAMPLE
This example shows how to set the access level and password for a user.
Security/Switch/Users>add steve polo 15
Security/Switch/Users>
security switch
users delete
This command deletes a user account.
SYNTAX
security switch users delete user-name
user-name - The name of the user. (Maximum length: 31
characters, case sensitive. Maximum users: 16)
EXAMPLE
Security/Switch/Users>delete steve
Security/Switch/Users>
PRIVILEGE LEVEL CONFIGURATION
This section describes the commands used to set the privilege level
required to read or configure specific software modules or system settings.
security switch
privilege level
configuration
This command shows the privilege level associated with read and write
access to various software modules.
COMMAND USAGE
Assigned privilege levels include the following access categories:
CRO – configuration read-only
CRW – configuration read/write
Table 26: Privilege Level Commands
Command Function
security switch privilege
level configuration
Shows the privilege level associated with read and write access to
various software modules
security switch privilege
level group
Sets the privilege level required for read or write access to various
software modules
security switch privilege
level current
Shows the privilege level of the user accessing the current
management interface
To Next Page
Loading...
