C
HAPTER
15
| Security Commands
Network Access Server Commands
– 366 –
security network
nas statistics
This command displays authentication statistics for the selected port –
either for 802.1X protocol or for the remote authentication server
depending on the authentication method.
SYNTAX
security network nas statistics [port-list] [clear | eapol | radius]
port-list - Applies this command to a specific port or a range of
ports. (Range: 1-28 or all)
clear - Clears all NAS statistics.
eapol - Shows statistics for the 802.1X protocol.
radius - Shows statistics for the remote authentication server.
DEFAULT SETTING
All ports
COMMAND USAGE
◆ This command provides detailed NAS statistics for a specific switch port
running EAPOL-based IEEE 802.1X authentication. For MAC-based
authenticated ports, it shows statistics only for the backend server
(RADIUS Authentication Server).
◆ For a description of the information displayed by this command, see
"Displaying Port Status for Authentication Services" on page 209.
EXAMPLE
Security/Network/NAS>statistics 1
Port 1 EAPOL Statistics:
Rx Total: 0 Tx Total: 0
Rx Response/Id: 0 Tx Request/Id: 0
Rx Response: 0 Tx Request: 0
Rx Start: 0
Rx Logoff: 0
Rx Invalid Type: 0
Rx Invalid Length: 0
Port 1 Backend Server Statistics:
Rx Access Challenges: 0 Tx Responses: 0
Rx Other Requests: 0
Rx Auth. Successes: 0
Rx Auth. Failures: 0
Security/Network/NAS>
To Next Page
Loading...
