C
HAPTER
15
| Security Commands
SNMP Commands
– 336 –
security switch
snmp trap probe
security engine id
This command displays or sets the SNMP trap security engine ID probe
mode.
SYNTAX
security switch snmp trap probe security engine id [enable |
disable]
enable - Enable SNMP trap security engine ID probe mode,
whereby the switch uses the engine ID of the SNMP trap probe in
trap and inform messages.
disable - Disables SNMP trap security engine ID probe mode.
DEFAULT SETTING
Enabled
EXAMPLE
Security/Switch/SNMP/Trap>probe security engine id enable
Security/Switch/SNMP/Trap>
security switch
snmp trap security
engine id
This command displays or sets the SNMP trap security engine ID.
SYNTAX
security switch snmp trap security engine id [engine-id]
engine-id - Specifies the SNMP trap security engine ID.
(Range: 10-64 hex digits, excluding a string of all 0’s or all F’s)
DEFAULT SETTING
None
COMMAND USAGE
◆ SNMPv3 sends traps and informs using USM for authentication and
privacy. A unique engine ID for these traps and informs is needed.
When trap probe security engine ID is enabled (see page 336), the ID
will be probed automatically. Otherwise, the ID specified by this
command is used.
◆ The Trap Probe Security Engine ID must be disabled (see page 336)
before an engine ID can be manually entered with this command.
EXAMPLE
Security/Switch/SNMP/Trap>security engine id 800007e5017f000002
Please disable trap security engine ID probe first
Security/Switch/SNMP/Trap>probe security engine id disable
Security/Switch/SNMP/Trap>security engine id 800007e5017f000002
Security/Switch/SNMP/Trap>
To Next Page
