Digisol DG-GS4528S - 9 System Commands; System Configuration; Table 17: System Commands

– 265 –
9 SYSTEM COMMANDS
This section describes commands used to configure information that
uniquely identifies the switch, set the user name and password, reboot the
system, set the time zone, configure the log levels to display, and filter
management access to the switch through specified IP addresses.
system
configuration
This command displays a brief summary of information that uniquely
identifies the switch, or a full list of all configuration settings for all ports or
for a specified port or port range.
SYNTAX
system configuration [all [port-list]]
all - Displays a full list of all configuration settings.
port-list - Displays a full list of configuration settings for a specified
port or for a range of ports. (Range: 1-28, or all)
EXAMPLE
System>configuration
System Contact :
System Name :
System Location :
Timezone Offset : 0
MAC Address : 00-17-7c-0a-ef-6c
System Time : 1970-01-01 03:59:40 +0000
System Uptime : 03:59:40
Software Version: DG-GS4528S (standalone) V1.1.0.3
Software Date : 2010-07-20 17:42:15 -0400
Table 17: System Commands
Command Function
system configuration Displays information that uniquely identifies the switch
system name Displays or sets the name assigned to the switch system
system contact Sets the name of the administrator responsible for the system
system location Displays or sets the system location
system timezone Displays or sets the time zone for the switch’s internal clock
system reboot Restarts the system
system restore default Restore factory default settings
system load Displays information on CPU utilization
system log Displays log entries, configures the log levels to display, or clears
the log table