ā 449 ā
21 LLDP-MED COMMANDS
LLDP-MED (Link Layer Discovery Protocol - Media Endpoint Discovery) is an
extension of LLDP intended for managing endpoint devices such as Voice
over IP phones and network switches. The LLDP-MED TLVs advertise
information such as network policy, power, inventory, and device location
details. Both LLDP and LLDP-MED information can be used by SNMP
applications to simplify troubleshooting, enhance network management,
and maintain an accurate network topology.
This section describes the commands used to configure LLDP-MED.
lldpmed
configuration
This command shows the LLDP-MED configuration.
SYNTAX
lldpmed configuration [port-list]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
DEFAULT SETTING
All ports
COMMAND USAGE
For a description of the information displayed by this command, see
"Configuring LLDP-MED TLVs" on page 166.
Table 51: LLDP-MED Commands
Command Function
lldpmed configuration Shows the LLDP-MED configuration
lldpmed civic Shows or sets the LLDP-MED civic address location
lldpmed ecs Shows or sets the LLDP-MED emergency call service
lldpmed policy delete Deletes the selected policy
lldpmed policy add Adds a policy to the list of polices
lldpmed port policies Shows or sets LLDP-MED port policies
lldpmed coordinates Shows or sets LLDP-MED location
lldpmed datum Shows or sets LLDP-MED coordinates map datum
lldpmed fast Shows or sets LLDP-MED fast start repeat count
lldpmed info Shows LLDP-MED neighbor device information
lldpmed
debug_med_transmit_var
Shows or sets the current value of the global medTansmitEnable
variable
To Next Page
