C
HAPTER
27
| MVR Commands
– 486 –
mvr port mode This command displays or sets the MVR operational mode for specified
ports.
SYNTAX
mvr port mode [port-list] [enable | disable]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
enable - Enables MVR operational mode for specified ports.
disable - Disables MVR operational mode for specified ports.
DEFAULT SETTING
Disabled
COMMAND USAGE
◆ When MVR is enabled for a port, MVR must also be globally enabled on
the switch for this setting to take effect.
◆ MVR only needs to be enabled on a receiver port if there are
subscribers receiving multicast traffic from one of the MVR groups.
EXAMPLE
MVR>port mode 1-2 enable
MVR>
mvr multicast vlan This command displays or sets the MVR VLAN ID.
SYNTAX
mvr multicast vlan [vlan-id]
vlan-id - Identifier of the VLAN that serves as the channel for
streaming multicast services using MVR. (Range: 1-4095)
DEFAULT SETTING
100
COMMAND USAGE
MVR source ports should be configured as members of the MVR VLAN, but
MVR receiver ports should not be manually configured as members of this
VLAN.
EXAMPLE
MVR>multicast vlan 2
MVR>
To Next Page
Loading...
