C
HAPTER
2
| Initial Switch Configuration
Basic Configuration
– 47 –
where “string” is the community access string.
>snmp read community rd
>snmp read community
Read Community : rd
>
N
OTE
:
If you do not intend to support access to SNMP version 1 and 2c
clients, we recommend that you delete both of the default community
strings. If there are no community strings, then SNMP management access
from SNMP v1 and v2c clients is disabled.
TRAP RECEIVERS
You can also specify SNMP stations that are to receive traps from the
switch. To configure a trap receiver, enter the “snmp trap” commands
shown below, and press <Enter>.
“snmp trap version version”
“snmp trap commuity community-string”
“snmp trap destination host-address”
“snmp trap mode enable”
“snmp mode enable”
where “version” indicates the SNMP client version (1, 2c, 3), “community-
string” specifies access rights for a version 1/2c host, and “host-address” is
the IP address for the trap receiver. For a more detailed description of
these parameters and other SNMP commands, see "SNMP Commands" on
page 385. The following example creates a trap host for a version 1 SNMP
client.
>snmp trap version 1
>snmp trap community remote_user
>snmp trap destination 192.168.2.19
>snmp trap mode enable
>snmp mode enable
>snmp configuration
SNMP Mode : Enabled
SNMP Version : 1
Read Community : rd
Write Community : private
Trap Mode : Enabled
Trap Version : 1
Trap Community : remote_user
Trap Destination : 192.168.2.19
Trap IPv6 Destination : ::
Trap Authentication Failure : Enabled
Trap Link-up and Link-down : Enabled
Trap Inform Mode : Disabled
Trap Inform Timeout (seconds) : 1
Trap Inform Retry Times : 5
Trap Probe Security Engine ID : Enabled
Trap Security Engine ID :
Trap Security Name : None
To Next Page
Loading...
