ā 299 ā
13 VLAN COMMANDS
This section describes commands used to configure standard IEEE 802.1Q
VLANs port members and port attributes.
vlan configuration This command displays VLAN attributes for specified ports and lists the
ports assigned to each VLAN.
SYNTAX
vlan configuration [port-list]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
EXAMPLE
VLAN>configuration 1
Port Aware PVID Frame Type Ingress Filter QinQ
---- -------- ---- ---------- -------------- ----
1 Disabled 1 All Disabled Disabled
VID Ports
---- -----
1 1-28
VLAN>
Table 22: VLAN Commands
Command Function
vlan configuration Displays VLAN attributes for specified ports and list of ports
assigned to each VLAN
vlan aware Displays or sets whether or not a port processes the VLAN ID in
ingress frames
vlan pvid Displays or sets the VLAN ID assigned to untagged frames
received on specified ports
vlan frametype Displays or sets a port to accept all frame types, including tagged
or untagged frames, or only tagged frames
vlan ingressfilter Displays or sets ingress filtering for specified ports, which discards
frames tagged for VLANs for which it is not a member
vlan stag Sets the EtherType of all frames received on a port to 0x88a8
(IEEE 802.1ad)
vlan add Adds specified ports to a VLAN
vlan delete Deletes specified VLAN
vlan lookup Displays port members for specified VLAN
vlan status Displays information about the VLAN attributes assigned to a port
To Next Page
