C
HAPTER
10
| IP Commands
ā 280 ā
EXAMPLE
IP/IPv6>ping6 ::192.168.1.19
PING6 server ::192.168.1.19
recvfrom: Operation timed out
recvfrom: Operation timed out
recvfrom: Operation timed out
recvfrom: Operation timed out
recvfrom: Operation timed out
Sent 5 packets, received 0 OK, 0 bad
IP/IPv6>
ip ntp configuration This command displays the NTP operation mode and the IP address for any
configured time servers.
SYNTAX
ip ntp configuration
EXAMPLE
IP/NTP>configuration
IP NTP Configuration:
=====================
NTP Mode : Enabled
Idx Server IP host address (a.b.c.d) or a host name string
--- ------------------------------------------------------
1 0.north-america.pool.ntp.org
2
3
4
5
IP/NTP>
ip ntp mode This command displays or sets the client request mode for service from a
Network Time Protocol (NTP) server.
SYNTAX
ip ntp mode [enable | disable]
enable - Enables NTP client requests.
disable - Disables NTP client requests.
DEFAULT SETTING
Displays the configured mode.
COMMAND USAGE
NTP allows the switch to set its internal clock based on periodic updates
from an NTP time server. Maintaining an accurate time on the switch
To Next Page
Loading...
