Digisol DG-GS4528S - Mvr Group; Mvr Status; Mvr Mode

C HAPTER 27 | MVR Commands
– 485 –
mvr group This command displays the MVR groups active on the switch.
SYNTAX
mvr group
EXAMPLE
MVR>group
VID Group Ports
---- --------------- -----
100 239.255.255.250 2
MVR>
mvr status This command displays statistics for IGMP protocol messages used by MVR.
SYNTAX
mvr status
EXAMPLE
MVR>status
Rx Rx Rx Rx
VID V1 Reports V2 Reports V3 Reports V2 Leave
---- ---------- ---------- ---------- ----------
100 0 3 2 0
MVR>
mvr mode This command displays or sets the global MVR operational mode.
SYNTAX
mvr mode [enable | disable]
enable - Enables MVR on the switch.
disable - Disables MVR on the switch.
DEFAULT SETTING
Disabled
COMMAND USAGE
When MVR is enabled on the switch, any multicast data associated with an
MVR group is sent from all designated source ports, to all receiver ports
that have registered to receive data from that multicast group.
EXAMPLE
MVR>mode enable
MVR>