C
HAPTER
4
| Configuring the Switch
Configuring Security
– 91 –
CONFIGURING SNMPV3 GROUP ACCESS RIGHTS
Use the SNMPv3 Access Configuration page to assign portions of the MIB
tree to which each SNMPv3 group is granted access. You can assign more
than one view to a group to specify access to different portions of the MIB
tree.
CLI REFERENCES
◆ "SNMP Commands" on page 326
PARAMETERS
The following parameters are displayed on the SNMPv3 Access
Configuration page:
◆ Group Name - The name of the SNMP group. (Range: 1-32 characters,
ASCII characters 33-126 only)
◆ Security Model - The user security model. (Options: any, v1, v2c, or
the User-based Security Model – usm; Default: any)
◆ Security Level - The security level assigned to the group:
■
NoAuth, NoPriv - There is no authentication or encryption used in
SNMP communications. (This is the default for SNMPv3.)
■
Auth, NoPriv - SNMP communications use authentication, but the
data is not encrypted.
■
Auth, Priv - SNMP communications use both authentication and
encryption.
◆ Read View Name - The configured view for read access. (Range: 1-32
characters, ASCII characters 33-126 only)
◆ Write View Name - The configured view for write access.
(Range: 1-32 characters, ASCII characters 33-126 only)
WEB INTERFACE
To configure SNMPv3 group access rights:
1. Click Configuration, Security, Switch, SNMP, Access.
2. Click Add New Access to create a new entry.
3. Specify the group name, security settings, read view, and write view.
4. Click Save.
To Next Page
Loading...
