C
HAPTER
15
| Security Commands
ACL Commands
– 368 –
6 1
7 1
8 1
9 1
10 1
11 1
12 1
13 1
14 1
15 1
Security/Network/ACL>
security network acl
action
This command displays or sets the default action for specified ports,
including permit/deny, rate limiters, port copy, logging, and shutdown.
SYNTAX
security network acl statusacl action [port-list] [permit | deny]
[rate-limiter] [port-copy] [logging] [shutdown]
port-list - A specific port or range of ports. (Range: 1-28, or all)
permit - Permits a frame if it matches a rule defined in the
assigned policy (see the security network acl policy command on
page 369).
deny - Denies a frame if it matches a rule defined in the assigned
policy (see the security network acl policy command).
rate-limiter - Specifies a rate limiter (see the security network acl
rate command on page 369) to apply to the port. (Range: 1-15, or
disable)
port-copy - Defines a port to which matching frames are copied.
(Range: 1-28, or disable)
logging - Enables logging of matching frames to the system log.
(Options: log or log_disable)
Use the system log command (page 269) to view any information
stored in the system log for this entry. Related entries will be
displayed under the “info” or “all” logging levels.
shutdown - Shuts down a port when a matching frame is seen.
(Options: shut or shut_disable)
DEFAULT SETTING
Forwarding: Permit
Rate Limiter: Disabled
Port Copy: Disabled
Logging: Disabled
Shutdown: Disabled
To Next Page
