C
HAPTER
2
| Initial Switch Configuration
Basic Configuration
– 42 –
Username: admin
Password:
Login in progress...
Welcome to DigiSol Command Line Interface.
Type 'help' or '?' to get help.
Port Numbers:
+-------------------------------------------------------------+
| +--+--+--+--+ +--+--+--+--+ +--+--+--+--+ +----+ +----+ |
| | 1| 3| 5| 7| | 9|11|13|15| |17|19|21|23| | 27 | | 28 | |
| +--+--+--+--+ +--+--+--+--+ +--+--+--+--+ +----+ +----+ |
| | 2| 4| 6| 8| |10|12|14|16| |18|20|22|24| | 25 | | 26 | |
| +--+--+--+--+ +--+--+--+--+ +--+--+--+--+ +----+ +----+ |
+-------------------------------------------------------------+
>
BASIC CONFIGURATION
SETTING PASSWORDS If this is your first time to log into the console interface, you should define
a new password for access to the web interface, record it, and put it in a
safe place. The password can consist of up to 8 alphanumeric characters
and is case sensitive. To prevent unauthorized access to the switch, set the
password as follows:
Type “system password password,” whe re password is your new password.
>system password ?
Description:
------------
Set or show the system password.
Syntax:
-------
System Password [<password>]
Parameters:
-----------
<password>: System password or 'clear' to clear
>system password admin
>
SETTING AN IP
A
DDRESS
You must establish IP address information for the switch to obtain
management access through the network. This can be done in either of the
following ways:
◆ Manual — You have to input the information, including IP address and
subnet mask. If your management station is not in the same IP subnet
as the switch, you will also need to specify the default gateway router.
To Next Page
