Digisol DG-GS4528S - Port Mode; Port Flow Control

C HAPTER 11 | Port Commands
– 285 –
port mode This command displays or sets port speed and duplex mode of a port.
SYNTAX
port mode [port-list] [10hdx | 10fdx | 100hdx | 100fdx | 1000fdx
| auto]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
10hdx - Supports 10 Mbps half-duplex operation
10fdx - Supports 10 Mbps full-duplex operation
100hdx - Supports 100 Mbps half-duplex operation
100fdx - Supports 100 Mbps full-duplex operation
1000fdx - Supports 1 Gbps full-duplex operation
auto - Enables auto-negotiation. When using auto-negotiation, the
optimal settings will be negotiated between the link partners based
on their advertised capabilities.
DEFAULT SETTING
Auto-negotiation
COMMAND USAGE
N OTE : The 1000BASE-T standard does not support forced mode. Auto-
negotiation should always be used to establish a connection over any
1000BASE-T port or trunk. If not used, the success of the link process
cannot be guaranteed when connecting to other types of switches.
EXAMPLE
Port>mode 5 100hdx
Port>mode 5
Port Mode Link
---- ------ ----
5 100hdx Down
Port>
port flow control This command displays or sets the flow control mode.
SYNTAX
port flow control [port-list] [enable | disable]
port-list - A specific port or a range of ports. (Range: 1-28, or all)
enable - Enables flow control.
disable - Disables flow control.