Digisol DG-GS4528S - Page 327

C HAPTER 15 | Security Commands
SNMP Commands
– 327 –
security switch snmp trap
community
Displays or sets the community string for SNMP traps
security switch snmp trap
destination
Displays or sets the SNMP trap destination’s IPv4 address
security switch snmp trap
ipv6 destination
Displays or sets the SNMP trap destination’s IPv6 address
security switch snmp trap
authentication failure
Displays or sets the SNMP authentication failure trap mode
security switch snmp trap
link-up
Displays or sets the port link-up and link-down trap mode
security switch snmp trap
inform mode
Displays or sets the SNMP trap inform mode
security switch snmp trap
inform timeout
Displays or sets the SNMP trap inform time-out
security switch snmp trap
inform retry times
Displays or sets the SNMP trap inform retry times
security switch snmp trap
probe security engine id
Displays or sets the SNMP trap security engine ID probe mode
security switch snmp trap
security engine id
Displays or sets the SNMP trap security engine ID
security switch snmp trap
security name
Displays or sets the SNMP trap security name
security switch snmp
engine id
Displays or sets the SNMPv3 local engine ID
security switch snmp
community add
Adds or modifies an SNMPv3 community entry
security switch snmp
community delete
Deletes an SNMPv3 community entry
security switch snmp
community lookup
Displays SNMPv3 community entries
security switch snmp user
add
Adds an SNMPv3 user entry
security switch snmp user
delete
Deletes an SNMPv3 user entry
security switch snmp user
changekey
Changes an SNMPv3 user password
security switch snmp user
lookup
Displays SNMPv3 user entries
security switch snmp
group add
Adds an SNMPv3 group entry
security switch snmp
group delete
Deletes an SNMPv3 group entry
security switch snmp
group lookup
Displays SNMPv3 group entries
security switch snmp view
add
Adds or modifies an SNMPv3 view entry
security switch snmp view
delete
Deletes an SNMPv3 view entry
Table 32: SNMP Commands (Continued)
Command Function