13 Automation Cues
An Automation Cue is an action/demand that is sent from the DCP-2000 to any external device
connected to the DCP-2000 for the purpose of being inserted into a Show Playlist. Upon
installation of the DCP-2000, Automation Cues can be pre-defined by the operator, transferred
from an “xml” file, or added manually. Automation Cues can be added to CPL's and SPL's using
CineLister.
13.1 Macro Automation Cues
A Macro Automation Cue consists of two parts, an Automation Cue and a Trigger Cue. Trigger
Cues are explained fully in Section “Trigger Cues” below. A Trigger Cue is an action that is sent to
the DCP-2000, whereas an Automation Cue is sent from the DCP-2000. Also, Macro Cues are a
sequence of actions, whereas an Automation Cue is only one action.
13.2 Macro Creation Using Macro Editor
• Go to Menu and click on Doremi Apps., then select Macro Editor.
• The Macro Editor GUI will appear ( Figure 164).
• Click on the “New Macro” button to begin the creation process.
• You will be prompted to enter a name for the Macro Automation Cue ( Figure 165).
• Click the Ok button when you are done and the Macro Editor GUI will re-appear.
• Click on Save after you are done creating the Macro Automation Cue.
• The new macro will appear in the Macro Editor Window (Figure 166).
• Click the Save button when you are done.
______________________________________________________________________________________
D2K.OM.001822.DRM Page 131 of 177 Version 1.5
Doremi Labs
To Next Page
Loading...
