dSPACE DS1103 User Manual

For detailed information (I/O circuits, electrical characteristics, etc.) on
the I/O lines terminating at the I/O connector, see Signal Connection
to External Devices on page 161.
Signal specification
Because the pin numbering used for KEL connectors is not
standardized, the following figure shows the numbering scheme used
(front view of the board connector).
Do not rely on the numbers written on the KEL
connectors.
Pinout of analog connector
(P1)
s
Connector Pinouts and LEDs
t
108
s
DS1103 Hardware Installation and Configuration November 2014

dSPACE DS1103 Specifications

General

Brand	dSPACE
Model	DS1103
Category	Controller
Language	English