Using the adapter cable supplied with the board, the incremental
encoder/digital connector (P3) can be linked to two 50-pin, female
Sub‑D connectors (labeled P3A, P3B).
Adapter cable
For detailed information (I/O circuits, electrical characteristics, etc.) on
the I/O lines terminating at the I/O connector, see Signal Connection
to External Devices on page 161.
Signal specification
Because the pin numbering used for KEL connectors is not
standardized, the following figure shows the numbering scheme used
(front view of the board connector).
Do not rely on the numbers written on the KEL
connectors.
The following table shows the pin assignment of the incremental
encoder/digital connector (P3). It also provides the mapping to the
Sub-D connectors of the adapter cable.
Pinout of connector (P3)
s
Connector Pinouts and LEDs
t
118
s
DS1103 Hardware Installation and Configuration November 2014
To Next Page
Loading...
