Troubleshooting
Service Instructions 755 A/756 A - 00.0 - 02/2019 467
9016 Seam program not active • Activate seam program
• Select a different seam program
9100 Piece counter has reached the
preset value.
Reset counter value
9500 Test loading process step by step Resume the process after pushing
the start pedal
9501 Test step by step Use pedal for progress
9601 Pedal was pressed backwards
during sewing
Press pedal again
9602 Empty bobbin Change bobbin
9603 Thread breakage Insert thread
9604 Light barrier for sewing material
removal not active
Set light barrier for sewing material
removal
9605 Transport clamp moves
9700 Folder not up Correct folder setting
9701 Folder not down Correct folder setting
9702 Folder not vertical Correct folder setting
9703 Folder not slanted Correct folder setting
9704 Folder not on the piping table Correct folder setting
9705 Front corner knife not down Correct the corner knife setting
9706 Rear corner knife not down Correct the corner knife setting
9707 Scissors not down Correct the scissors setting
9708 Scissors not up Correct the scissors setting
9709 Bobbin case retainer not up Correct the downholder setting
9710 Switch S05 for the loading station
does not react
Set the switch S05 for the loading
station
Error code Symbol Meaning Remedial action
To Next Page
Loading...
Need help?
General
