Single Cue Lists 323
Example:
If you are currently in cue 5 and you want to update through cue 10, you
would use the following syntax:
[Update] [Thru] <Cue> [10] <CueOnly/Track> [Enter]
Update [+]
[+] can be used to specify a range of cues for updating. [+] can also be used with [Record] and
[Record Only].
Example:
To update only cues 5, 10, and 15:
[Update] <Cue> [5] [+] <Cue> [1][0] [+] <Cue> [1][5]
<CueOnly/Track> [Enter]
To update the current cue and cue 7:
[Update] [+] <Cue>[7] <CueOnly/Track> [Enter]
Note:
If no cue number is entered before the [+], the current active cue will be used.
Recording and Editing Cues from Blind
When you press blind, the selected cue will be displayed. You can make changes to cues in the
blind display using either the summary, table, or spreadsheet views.
CAUTION:
Edits in blind take effect immediately. [Record] or [Update]
commands are not required in blind.
Note:
To force blind to the selected cue, press [Blind] [Blind].
If changes are made in the blind display to an active cue, these changes will not impact the
current stage state. To make blind changes active you can press [Assert] & {Load} button for
the fader associated with the cue, or you can use [Go To Cue] [Enter].
Move instructions can be removed from a cue by selecting the channel and pressing [At]
[Enter]. This allows all values from the previous cue to track into the current cue. You can also
use this command for specific parameters as well.
To Next Page
Loading...
