ETC Element 2 - Applying a Curve to Scroller Fans; Deleting Curves

Curves 435
Applying a Curve To Scroller Fans
Curves can also be applied to a scroller fan. When applied to a scroller fan, the output of the
fan will be controlled by the intensity of the channel. To apply a curve to a scroller fan, go to
Patch>Attributes>{Fan Curve}. See Scroller Fan Curves (on page175)
Deleting Curves
While in the curve display, you can delete a curve in the following ways:
•
[Delete] {Curve} [3] [Enter] [Enter] - deletes curve 3 from the list.
•
[Delete] {Curve} [9] [0] [1] [Enter] [Enter] - since curve 901 is a pre-established curve,
this command will return curve 901 to its default state, thereby removing any edits to it.
•
[Delete] [Enter] - deletes the currently selected curve.