ETC Element 2 - Fixtures in Augment3 D

Augment3d 499
Fixtures in Augment3d
Fixtures must be patched in Eos and then added to an Augment3d model before they can be
displayed and controlled.
Adding Fixtures Manually
If fixture position and orientation data is already known, fixtures can be manually added via
the Augment3d tab in the Eos Patch screen.
For more information, see Manually Adding Fixtures (on the next page)
Adding Fixtures Automatically
Alternatively, if fixture position data is not available, Augment3d can calculate the rotation
and XYZ position of fixtures using calibrated points placed at known locations throughout
your space.
For more information, see Fixture Position Estimation (FPE) (on page503) .
Adding Fixtures from Vectorworks
Finally, fixtures can be imported into an Augment3d model from a Vectorworks file. For more
information, see Vectorworks Augment3d Plug-in (on page518) .