Submasters 409
[Record] [Both Bump Buttons] - records all current values to the fader associated with
the bump buttons. Submaster will be stored with the number associated with the chosen
fader.
You can also record selected channel data to submasters as well.
[Channel List] [Record] [Sub] [5] [Enter] - records all data for the channel list to
submaster 5.
[Channel List] [Record Only] [Sub] [5] [Enter] - records manual data for the channel list
to submaster 5.
Submasters can also be recorded using selective storing, which allows you to specify only the
channels that you want stored.
[6] [Thru] [1][0] [Record] [Sub] [3] [Enter] - records only channels 6 through 10 to
submaster 3.
[1] [Thru] [5] {Blue} [Record] [Sub] [6] [Enter] - records only the blue color for channels 1
through 5.
[1] [Thru] [1][0] {Offset} {Odd} [Record] [Sub] [4] [Enter] - records channels 1, 3, 5, 7, 9
into submaster 4. For more information on using {Offset}, see
Offset (on page226)
If a submaster already has data stored to it, selective store will act as a merge function. Using
the above example of channels 6 through 10 stored to submaster 3, if you were to then store
channel 5 to submaster 3, that would be added to the current content so that channels 5
through 10 are now stored.
If you don't want the data to merge, you can either first delete the submaster to remove the
original content (see
Deleting a Submaster (on page418)
), or you can selective store while
using [Rem Dim].
[5] Record] [Sub] [3] [Rem Dim] [Enter] - records channel 5 to submaster 3 and removes
any previous data from the submaster.
Submaster List
You can access the submaster list by pressing [Sub] [Sub], [Tab] [1][5] or through the browser
(Record Target Lists>Submaster List>[Select]). Either of these commands will open a new tab
for the submaster list or if it is already open on a tab, will bring focus to the list.
The list view includes a list of all submasters including their labels and all properties. You can
navigate within the list by using the [Next] and [Last] buttons or by selecting the desired
submaster from the command line.
Editing Submasters
While in the Submaster list, if you want to edit the contents of the submaster, you can select
the submaster and press {Edit}. This changes focus to the Live/ Blind tab and places you into
the Blind edit mode for the specified submaster. You may also press [Blind] and select the
required submaster from the command line.
Any changes made in this screen are automatically stored. A [Record] or [Update] command is
not required.
Submaster Properties
Faders can be mapped to a submaster in the fader configuration display, or by recording or
loading a submaster. See
Fader Configuration (on page128)
,
Recording a Submaster (on the
previous page)
, or
Loading Submasters (on page415)
for more information.
To Next Page
Loading...
Need help?
General
