414 Eos Apex, Eos Ti, Gio, Gio @5, Ion Xe, Ion Xe 20, and Element 2 User Manual
Bump - plays back the submaster at 100% of the recorded level. It will continue to do so
until released, unless the submaster has a time assigned or the {Hold} property set.
Group/ Assert - selects all the channels associated with the submaster, if the submaster
is inactive. If the submaster is active, the contents of the submaster will be asserted.
Assert - regains control of all of the channels associated with the submaster.
Group Select - selects the channels stored in the submaster. This is the same as [Group]
[Sub] [n].
Freeze - halts all effect activity on the fader.
Off - removes the content and if the fader is set to Master, the fader will remain where it
currently is.
Release - removes the content and if the fader is set to Master, the fader will reset to 0.
Start Stop Effect -starts the effect while ignoring dwell times. Will stop effects if any are
running.
Button Disabled - no action is assigned to the button.
Mark NPs - If no non-intensity parameters are owned by the submaster, it will fade the
parameters on any dark channels in bump up time. If any non-intensity parameters are
owned by the submaster, it releases the non-intensity parameters in bump down time.
Dwell time and mode are ignored.
Solo - suppresses any intensity values not provided by the associated content while the
solo button is held down. When the button is released, intensity values are restored.
Priority and HTP are ignored. Shielded, park and pixel mapping outputs are not affected
by the solo button.
Back - fades to the previous cue when fader is assigned to a cue list.
Macro - allows you to assign a macro as a button action.
Fader Options
The following options are available for a submaster fader:
Master - fader will be a proportional master, a manual master, or an intensity master.
Effect Rate - fader centers to home. It controls the rate of any running effects (same
behavior as using rate via the Effect Status Display). The adjusted setting from this
control cannot be stored.
Effect Size - similar to Effect Rate but for effect size.
Rate Master - homes to center. It adjusts the cue rate, just like rate and load.
Fader Disabled - no action is assigned to the fader.
Master Only - fader is used to set a level for content to fade to. The slider can be used to
live adjust levels when the fader has been activated via the bump button. See
Master
Only (on page133)
for more information.
Effect Master - masters the entry/exit mode of the effects (size, rate or both).
Levels Only - masters the levels without mastering the effect.
Submaster Information
In the window above any programmed submaster, you will see the following:
On Element 2, you will see this information in the fader status display. See
Indicators in the
Element Fader Status Display (on page130)
Note:
Inhibitive submasters display in red and additive submasters in yellow.
Submaster number
Submaster label (if any)
Priority flag (if any)
To Next Page
Loading...
Need help?
General
