Manual Control 243
With the
Gel Picker
open and a gel selected, a dotted line will appear in the Spectrum display.
That line represents the selected gel.
{Hold Color Point} allows you to adjust individual emitters and the other emitters will
automatically adjust to hold the color selected. This can only be used with fixtures that have
more than three color parameters.
If you are working outside of this display, holding down [Color] while adjusting the encoders
will cause Hold Color Point behavior.
Home
Eos is equipped with a [Home] hardkey. As with the {Home} touchbutton on the Encoder
Display (see
Home (on page234)
). This hardkey allows you to home a specific parameter.
Additionally, you may home all of a channel’s non-intensity parameters or home only a specific
category (I, F, C, B).
Homing a channel, category, parameter, or submaster will return it to the default value.
[1] [Home] [Enter] - homes all parameters for channel 1, except intensity.
[1] [Color] [Home] [Enter] - homes all color parameters for channel 1.
[Group] [1] [Color] [Focus] [Home] [Enter] - homes the color and focus parameters of all
channels in group 1.
[Sub] [1] [Home] [Enter] - homes submaster 1.
[Sub] [1] [Thru] [Home] [Enter] - homes all submasters.
Home Preset
You can select a preset to provide home values for all non-intensity parameters (instead of
fixture library default values) when home commands are used. Store a preset with modified
home values for only the channel parameters you would like at a different value than default,
To Next Page
Loading...
Need help?
General
