Submasters 413
Note:
This option is for submasters that are set to Intensity Master.
Exclude
Those exclusions include:
Exclude From Record - output is not recorded into any other record target.
Exclude From Grandmaster - content cannot be mastered by a grandmaster.
Exclude From Inhibitive Sub - content cannot be mastered by an inhibitive submaster
Exclude From Solo - content will ignore solo. See
Submaster Fader and Button
Configuration (below)
for more information on solo.
Channel and Parameter Filters
Channel and Parameter Filters can be used to allow only specified data to be played back.
These are playback filters, and do not impact how data is recorded.
For submasters, channel and parameter filters can be set in the following areas:
Submaster List
In Live using the {Properties} softkey
Tap or click on {Chan Filter} to assign channels or groups. Tap or click on {Param Filter} to
open a list of available parameters that you can filter.
Note:
Filters will travel with their assigned submasters wherever they are mapped.
When a filter has been applied, an indicator will display in the fader ribbon. C will display for
channel filter, and F is for parameter filter.
Press the red [X] to clear the channel or parameter filters listed.
FX Off 0
Starts the effect when master fader is moved from 0, stops the effect when it is moved to 0.
This is enabled by default.
Submaster Fader and Button Configuration
Click or tap on the virtual buttons or fader to see a list of available configuration options.
Button Options
The following options are available for submaster buttons:
To Next Page
Loading...
Need help?
General
