362 Eos Apex, Eos Ti, Gio, Gio @5, Ion Xe, Ion Xe 20, and Element 2 User Manual
The following are additional modifiers that can be used with [Go To Cue]:
Homes a cue list to its first cue
[Go to Cue] [Home] [Enter] homes the currently selected cue list to its first cue. [Go to
Cue] [x] [/] [Home] [Enter] homes a cue list to its first cue.
Takes a cue list to its last cue
[Go to Cue] [Shift] [Home] [Enter] homes the currently selected cue list to its last cue.
[Go to Cue] [x] [/] [Shift] [Home] [Enter] will take you to the last cue in a cue list.
Go to Cue Out
[Go to Cue] [x] [/] [Out] [Enter] allows you to use the [Go to Cue] [Out] command on a
list specific basis. [Go to Cue] [Out] continues to affect all active cue lists.
Note:
[Go to Cue] [x] [/] [Out] is similar to [Go to Cue] [x] [/] [0] except that any NPs
on the fader will fade to their home level.
Time
[Go to Cue] [5] [Time] [Enter] will go to cue 5 using cue times, and also uses any
associated follow/hang times to automatically trigger the subsequent cue. To go to a cue
in cue time, but not trigger the follow/hang, you would use [Go to Cue] [5] {Minus
Links} [Time] [Enter].
Note:
If you want to specify a time or use the cue time, the [Time] command must
always be entered after any other commands, such as {Minus Links} or {SingleParam}.
The exception to this rule is {Manual}.
These can be combined within the command line as well:
[Go To Cue] [1] {MultiParam} {MovesOnly} [Enter]
Virtual Faders
You can have access to additional faders by using the virtual faders (see
Virtual Fader Module
(on page134)
).
Assigning Faders
Cue playbacks, submasters, grandmasters, palettes, and presets are targets that can be
assigned to faders.
Faders can be assigned in a number of different ways.
The fader configuration display
The fader list
The cue list index
The submaster display
Manually using the [Load] button
Element 2's cue list cannot be assigned to a fader. It can only be loaded on the master
playback fader pair.
With Auto Playback Enabled
Auto Playback is a record function enabled in Setup > User > Record Default, that
automatically executes cues recorded in live on playback faders. When the cue is executed on
the playback fader, any manual parameters involved in the record operation are automatically
released to the cue and all other values stored in the cue are owned by that cue.
To Next Page
Loading...
Need help?
General
