Cue Playback 361
Note:
A cue can be loaded with a temporary timing. See Loading a Cue With
Temporary Time (on the previous page).
[Go To Cue] [2] [Time] [1] [Enter] - this command would take you to cue 2 in one
second.
[Go To Cue] [3] [Time] [4] [/] [3] [Enter] - this command would take you to cue 3 and all
up fades and NP moves would have a time of four seconds and down fades of 3.
[Go to Cue] [Next] [Time] [3] [Enter] - this command would take you to the next cue in
the selected list in three seconds.
[Go to Cue] [Last] [Time] [2] [Enter] - this command would take you to the previous cue
in the selected list in two seconds.
[Go To Cue] [8] [Time] [Enter] - this command would take you to cue 8 using all timing
values stored in cue 8.
Other Go To Cue Options
When [Go to Cue] is pressed, the softkeys in the CIA change to provide Go to Cue modifiers to
enhance your playback ability.
From these softkeys, you can specify that when going to a cue, only some elements of that cue
will be played back. Specifically you can choose to play back:
Manual control using a fader
[Go to Cue] [6] {Manual} [Enter]
Scenes opens the
Scenes (on page313)
selection display.
[Go To Cue] {Scenes} - press or select a scene to go to that cue.
Move instructions only
[GoTo Cue] [3] {MovesOnly} [Enter]
Withhold any links (follow, hang, execute instructions)
[GoTo Cue] [4] {MinusLinks} [Enter]
Use marks
[GoTo Cue] [5] {Use Marks} [Enter] - delays channels from marking until their intensities
have reached zero.
Complete a cue
[Go To Cue] [4] {Complete} [Enter] will go to cue 4 and if that cue has a follow/ hang,
any following cues in the sequence will also fire. This may look like you are going
straight to the last cue in the sequence but each cue will fire to make sure that any
external links are fired.
[Go To Cue] [2] [At] [5][0] {Complete} [Enter] will go to cue 2 at 50% of its completion.
[Go to Cue] [5] [Time] [Go to Cue] will go to cue 5 using cue times, and append
[Complete] to the command line.
Single parameter channels only (conventionals)
[GoTo Cue] [1] {SingleParam} [Enter]
Multiple parameter channels only (automated fixtures)
[GoTo Cue] [2] {MultiParam} [Enter]
Note:
Double pressing [Go To Cue] will post Go ToCue Complete to the command
line. You can then select the appropriate cue number and level of completion.
To Next Page
Loading...
Need help?
General
