EasyManuals Logo

ETC Element 2 User Manual

ETC Element 2
693 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #691 background imageLoading...
Page #691 background image
Regulatory 677
Regulatory
Apex 5, 10, and 20, Apex Remote Processor, Eos Remote
Interface, and Windows 10-based Ion Xe, Ion Xe20, Ion Xe
RPU, Gio@5, and Element 2
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Contains Model: 9260NGW
Contains FCC TX ID: PD99260NG
Canada IC:1000M-9260NG
Japan
RF:003-170125
TEL:D170079003
South Korea
MSIP-CRM-INT-9260NGW
WARNING: This device contains a lithium battery. Battery may explode if
mistreated. Do not recharge, disassemble or dispose of in fire.
CAUTION:
Power cord must be connected using an earth ground
connection.
A fuse is included for additional protection. Fuse ratings can be found on the rear panel of
your console.

Table of Contents

Other manuals for ETC Element 2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ETC Element 2 and is the answer not in the manual?

ETC Element 2 Specifications

General IconGeneral
DMX Outputs2
TouchscreenYes
NetworkingEthernet
TypeLighting Control Console
Master Faders2
Encoders4
Ethernet Ports2
USB Ports4
Video OutputDisplayPort
Power Input100-240VAC, 50/60Hz
Power SupplyInternal
Control Channels6144
OutputArt-Net
DisplayMulti-Touch LCD
StorageSolid State Drive (SSD)

Related product manuals