Europlex 3GS - Access Control Setup Examples

3GS Technical Manual
Issue 4.5 August 2005
Programming Overview 7-7
Access Control Setup Examples
Example 1
To pass a card (with a card number of 1 and a site code of
1000) for all doors on the system for 24 hour access. The card
must be presented to each door when entry is required at any
time of the day.
SETUP
1 Setup Door Group 1 (see page 2-57)
- Installer code SHIFT SHIFT 3
- Select ’Setup’
- Enter door group 1
- Press # (enter)
- Select all doors by pressing * key. All dots (.) on the
display change to asterix (*)
- Press #
- Quit back to Date & Time using NO key
2 Setup Access Level 1 (see page 2-59)
- Installer code SHIFT SHIFT 8
- Select ’Access’
- Select ’Groups - Times’
- Enter group/time 1
- Press #
- Enter door group no.1 and press #.
- Enter time zone 0 (24 Hr)
- Press #
- Quit back to ’Group - Times Access’
- Select ’Access’
- Enter access level 1
- Press #
- Set Group/Time 1 to YES
- Press #
- Quit back to Date & Time using NO key
- Access level 1 is setup for group/time 1, which is
door group 1 for 24 hour access
3 Setup Site Code (see page 2-45)
- Installer code SHIFT SHIFT 6
- Select ’Cards’
- Select ’site code’
- Enter 0000001000 and press #.
- Quit back to Date & Time using NO key.
4 Assign Card no.1 onto the System (see page 2-43)
- Installer code SHIFT SHIFT 6
- Select ’cards’
- Select ’assign’
- Select card No. 1. Press #
- To card no 1. Press #
- Card no.1 is now assigned to card ID 1
- Quit back to ’Date and Time’ using NO key
5 Pass Card 1 for all Doors for 24 hour Access (see page
2-46)
- Installer Code SHIFT SHIFT 6
- Select 'Pass/Void-To 'Pass Cards?' Press Yes.
- At 'From card No.' Enter 1.
- Press #
- To 'Change Access Level?' Press Yes.
- At 'Enter Access Level ?' Enter 1.
- Press #.
- Quit back to Date and Time using NO key.
The card is now passed for all doors for 24 hours
a day.
This setup can be greatly simplified by using Europlex’s
Access Management Software 3GS+.