Issue 4.5 August 2005 Europlex Universal Interface Card (EUIC) 11-8
EUIC PROGRAMMING SOFTWARE
To install the software
1 The EUIC is supplied with a Windows 95/98 based programming application. It requires a PC with a 100MHz
Pentium processor and 32MB of RAM or better.
2 Insert the floppy disk provided and open the appropriate drive in Windows Explorer.
3 Double click on setup.exe to start the installation.
4 Follow the Installshield instructions for the selection of the destination directory and program options.
5 To start the application, click on the Start button, select the Programs folder, and click on Euic_Programmer.
6 To get information on all the EUIC hardware and programming features, select the Help option on the main
program window.
Hyper Terminal
If Hyper Terminal is used for programming the EUIC, then the suggested settings in default mode are as follows.
Phone Number
● Direct to: Com Port 1
● Bits per second: 9600
● Parity: none
● Stop bits: 2
● Flow control: none.
Settings Menu
● Terminal keys
● Emulator auto detect
● Back scroll buffer lines
ASCII Settings Sending
● Send line ends with line feeds
● Echo typed characters locally
ASCII Settings Receiving
● Append line feed to incoming line ends
● Force incoming data to 7 bit ASCII
● Wrap lines that exceed terminal width
To Next Page
