16 - 8
UPGRADING
Upgrading from 3GS+ 1.17 or 1.17a to 3GS+ 2.0
Note You can only upgrade from 1.17 or 1.17a
Steps Involved
햲
Make a copy of the following mdb files and save them to a new directory.
data3gs.mdb
datalog.mdb
ipanal.mdb
햳
Through the Control Panel uninstall 3GS+ Version 1.17 or 1.17a. Once it has been uninstalled check that
there are no files in the directory where 3GS+ 1.17 was installed other than the backup directory (3gs) if
there was one.
햴
Install 3GS+ 2.0 (By running the setup.exe located on the CD Refer To: Installing 3GS+). If there is a file
conflict always choose to keep original file.Ignore any Access Violations and continue to load 3GS+.
햵
Copy over the mdb files that were saved in step 1 to the directory where 3GS+ 2.0 has been installed
햶
Copy the files located on the 3GS+ CD in the directory "Upgrade 1.17 or 1.17a to 2.0" to the directory
where 3GS+2.0 has been installed. This will result in overwriting some files so if prompted say "Yes".
햷
From the directory where 3GS+ 2.0 has been installed run the program Upgrade3GS5.0.exe. It will display a
message informing the user whether the upgrade has been successfully run.
To Next Page
Loading...
