Europlex 3GS - Remote Keypad Display (RKD) Node

Issue 4.5 August 2005 Nodes 5-7
REMOTE KEYPAD DISPLAY (RKD) NODE
Description
The Remote Keypad Display (RKD) node is a wall mounted unit that allows you to control, program, and observe the
past or present state of the 3GS system or to arm/disarm the system. The RKD is capable of monitoring its own supply
voltage and its integral front and back tamper switches. Like all system nodes, the RKD will have been automatically
assigned a unique address following a power up.
햲 2x24 Character LCD Display This display is used to show all alert and warning messages and menus.
The display contrast and backlight can be adjusted through the menus.
See Node Configure->Outputs in 3GS Programming for further information.
햳 LED status indicators The three LEDs to the right
of the numeric keypad indicate the system’s current
status, as follows:
● Yellow LED: Indicates the occurrence of a system
event. An alert or warning message will indicate the
location and nature of the event.
● Green LED: Indicates the presence, or failure of,
the mains supply.
● Red LED: Remains steady to indicate a fault on
both communications lines, and displays two
distinctive flashing sequences to indicate a fault on
either communications line.
LED
S
t
ead
y
LED
F
l
a
s
h
i
n
g
Mainssupplyfailure
Sy st e m
al ert mes s age
Sy s t em
wa r ni n g messag e
Mai n s supply present
Green
Communications lost line 1A 1B
(flashes off every 2-3 seconds.) once
Commun i c at i o ns lost line 2A 2B
(flashes off every 2-3 seconds.) tw ic e
Communicati ons lost
Yellow
Red
CommunicationsOK
(flashes brie
f
ly
every 2-3 seconds.)
on