Europlex 3GS - Radio PA Setup

3GS Technical Manual
Issue 4.5 August 2005
8-34 Programming Menus
RADIO PA SETUP
Function: This menu allows you to set up the pager to transmit to pager receivers and set up the radio panic attack button units.
Additional Information
Buttons
Select Buttons to assign a single button or a combination of buttons to an option. Up to 7 different button configurations may be obtained by
pressing the buttons singularly and as combinations. This allows all six options to be assigned to a RPA. Note that these options must be
granted to the RPA within the Radio PA Assign - Options submenu (see page 8-89) in order for the RPA to operate.
Note The assignment that is made to one RPA button(s) is the same for every RPA unit on the system. For example,
if the left button on RPA 1 is assigned as Raid, every RPA left button is also assigned as Raid.
Pager
Each pager unit has a unique 7 digit address. Key in this address as shown and select the test function to send a message to the
relevant pager.
menu