3GS Technical Manual
Programming Menus 8-61
Issue 05 April 2005
SETUP SIA
Function: This menu allows you to select an SIA record, set a reporting delay of 0 to 99 seconds, and set a combination of two
phone numbers to be used to report the record to the central station. The DM1200 can be programmed to report to
both telephone numbers (x AND y) or either teleephone number (x OR y).
Additional Information
SIA Reporting
SIA (Security Industries Association) reporting provides greater precision in the reporting of alarm events via a communications
device to a Central Station. When used with a Europlex DM1200 digital communicator, SIA will add user name and zone
information to every event reported and will prioritise events for immediate transmission or for transmission following a pre-set
time delay. Once the DM1200 has been configured and tested – see “Set Up DM1200” on page 8-79 – SIA Reporting is
automatically enabled for that panel. Standard alarm events are assigned SIA codes, according to the table below.
SIA is standard on Version 5.00 software and is only available on the Europlex DM1200 digital communicator Version 3 or
greater.
Note Setting the phone numbers for a particular record to '0 or 0' will disable the reporting of this record.
For example:
menu
To Next Page
Loading...
