3GS Technical Manual
Issue 4.5 August 2005
8-94 Programming Menus
COMMAND MODE
Function: This menu provides you with direct access to the power of the command string interpreter.
Additional Information
WARNING: This function is for advanced users only and any modifications to literals may compromise the operation of the
system.
When a command string is entered, the 3GS will execute it immediately. Should an error occur during the execution, a SYNTAX
ERROR message is displayed and the command string aborted.
Any command string up to the maximum length of 127 characters may be entered. A blank display is presented each time, but the
most recently entered string is stored in literal 498. The most commonly used and simple commands are for direct control of the
system outputs.
For example:
S2 Will set output 2, both the on-board relay and any other node outputs assigned as output 2.
R2 Resets the same output.
B1841 Will generate an unused RKD sound pattern.
B0 Will turn off the RKD buzzer.
To Next Page
Loading...
