3GS Technical Manual
Issue 4.5 August 2005
8-90 Programming Menus
Raid
The Raid option causes an instant silent alarm. When selected, this option turns on the Panic and Raid-Camera outputs and
triggers the pager units immediately. NO alert appears on the RKD until a System Unset/Disarm is performed, whereby a Radio
Panic Alarm is displayed along with the RPA description that triggered the alert. The action is recorded in the system log.
Delayed Raid (*)
This option operates identically to the Raid option except that the activation of the Panic output is delayed for 90 seconds. This
provides the opportunity to cancel the panic output (assuming the Raid Cancel option has been granted) and therefore prevent
consequent action – for example, central station communications.
Raid Cancel (*)
This option resets the Panic and Raid-Camera outputs provided it has been selected within 90 seconds of the Panic output being
triggered. The pager units are triggered and the action is recorded in the system log. The user must still unset/disarm the system to
clear the Panic alert messages.
Suspicion
When selected, this option turns on the suspicion output (which will typically activate the same camera as the raid camera output)
and triggers the pager units immediately. A suspicion alert is displayed with the RPA description that triggered the alert and is
recorded in the system log.
Photo Entry
When selected, this option turns on the suspicion output for approximately 5 seconds which will activate a CCTV camera and
record personnel entering the premises.
(*) - These options are not available in version 5.81 3GS Software
To Next Page
Loading...
