269
MIDSECTION
STERN BRACKET, 90 HP MANUAL TILT
11
Assemble st arboard t rail lock lever and trail lock
spring to reverse lock pivot shaft.
Install nylon wa sher on trail lock shaft and inst all
above components into swivel bracket. Install trail
lock wash er, ap ply blue Nut Lock to screw a nd
install scre w. Tighten both screws to a torq ue of
60 to 84 in. lbs. (7 to 9.5 N·m).
Install remaining bellcrank shaft spacer on reverse
lock pivot shaft, then install retaining ring.
Install the handle link rod to reverse lock lever and
bellcrank. Install b ellcrank on reverse lock pivot
shaft. Tighten the setscrew.
Install the port re verse lock link on t he swive l
bracket. Install washer screw. Apply blue Nut Lock
to screw thre ads a nd in stall washer an d screw .
1. Trail lock lever
2. Trail lock spring
3. Reverse lock pivot shaft and rod
006691
1. Reverse lock pivot shaft
2. Trail lock lever
006692
1. Retaining ring 006693
1. Handle link rod
2. Reverse lock lever
3. Bellcrank setscrew
006694
To Next Page
Loading...
