DMP 128 FlexPlus • Dante Controller 109
Dante Controller
This section describes the DMP 128 FlexPlus network installation, configuration, and control
using Dante Controller for Windows and covers the following topics:
• Overview
• Downloading and Installing Dante Controller
• Configuring the DMP 128 FlexPlus in Dante Controller
• Physical Dante Network Setup
• Dante Controller Operation
• Dante Routing Operation
• Dante Troubleshooting
Overview
DMP 128 FlexPlus devices (DMP 128 FlexPlus C AT and C V AT) use Dante technology
by Audinate to provide high performance digital audio networking over standard TCP/IP
networks. The Dante Controller software application is used to route audio on the network.
Dante allows audio channels to be transported across a switched Ethernet data network
while meeting the quality requirements of professional audio.
Up to 24 channels can be transmitted from the DMP 128 FlexPlus to the Dante network and
up to 48 channels can be received by the DMP 128 FlexPlus from the Dante network. AT
inputs 33 through 48 can be used to facilitate EXP bus communication (see Connecting a
DMP 128 FlexPlus Device and an EXP-enabled non-AT Device on page97).
Audio signals are converted by DMP 128 FlexPlus devices, processed and routed to the
AT bus, and transmitted onto the Dante network. Audinate recommends the Dante audio
network be kept separate from other networks. However, the audio network can be shared
with control traffic or unrelated data traffic. Audio channels can be unicast or multicast to
make the best use of available bandwidth.
To Next Page
Loading...
Need help?
General
