DMP 128 FlexPlus • DSP Configurator Software 53
Mix-Points
DSP Configurator contains twelve mix matrices that connect all inputs and outputs (see
figure 88 on the next page). The mix matrices set post-processing mix levels.
Each input is connected to a mix-point for the signal to be routed to an output. In general,
mix levels are set relative to each other, achieving a blend of input signals at an optimal
output level, close to, but not exceeding 0 dBFS at the output.
NOTE: In order for mix-points to appear in the workspace, the input group sending
signal to the mix-point must be expanded and the input channel must be visible.
To Next Page
Loading...