DMP 128 FlexPlus • Dante Controller 111
Receiver and Transmitter Names
In addition to renaming a device, individual transmitter and receiver channels can be
renamed in Dante Controller. Rename transmitter and receiver channels to reflect the
location of the device or the purpose of the transmitter or receiver. Ensure transmitter and
receiver channels are renamed before making audio connections between devices. Refer to
Renaming a Receiver or Transmitter on page113 for renaming procedure.
Dante Controller Naming Conventions
• Device names follow Domain Name System (DNS) hostname rules. Legal characters are
A-Z, a-z, 0-9, and hyphen (-). Names must begin with a letter and cannot end with a
hyphen (-).
• Dante Tx and Rx channel names (also known as labels) can be up to 31 characters in
length. Label names are not case-sensitive. For example, “ANALOG OUT-1” and “analog
out-1
” are recognized as the same name. Unicode and non-roman characters are not
supported.
• Tx and Rx channel labels can use any character except equals (=), period (.), or @.
• Tx and Rx channel labels must be unique on a device but do not need to be unique on
the network.
Renaming the DMP 128 FlexPlus in Dante Controller
NOTE: Dante device naming can also be done via DSP Configurator (see Dante Device
on page95).
1. Ensure that the control computer and a single DMP 128 FlexPlus are connected to the
same network.
2. From the control computer Start menu select:
All Programs > Audinate > Dante Controller > Dante Controller
3. The Dante Controller - Network View screen opens. All Dante devices on the
network are discovered and listed.
4. From the Device menu, select Device View or press <Ctrl+D> on the keyboard (see
figure 171 below).
Figure 171. Opening Device View
161 Opening Device View
To Next Page
Loading...
Need help?
General
