Faro Edge - Main Menu

FARO Edge
September 2012
88
Chapter 6: Maintenance and Troubleshooting
• WLAN is disabled if Ethernet is active
• WLAN is disabled if Bluetooth is active
FARO i-Probe FAQ
• Can I use an i-Probe on anything other than the Edge?
Yes . ONLY on a FaroArm Quantum. Installing the i-Probe to anything other
than a FaroArm Quantum damages the i-Probe.
• Can I still use my old probes on the Edge?
Yes. However you must clear the U
SE I-PROBE check box in the PROBE
dialog box. For more information, see “Probes” on page 178.
• I have an i-Probe attached but see this error dialog box and can not measure.
What is wrong?
Compensate the i-Probe. For more information, see “Compensate Probe” on
page 181.
• I have an i-Probe attached but see this error dialog box and can not measure.
What is wrong?
Ensure that the i-Probe is threaded on all the way. If the system still does not
recognize it, the i-Probe may be damaged and may need to be replaced.
08M52E00_FaroArm_Edge.book Page 88 Thursday, October 4, 2012 9:31 AM