FARO Edge
September 2012
79
Chapter 6: Maintenance and Troubleshooting
Chapter 6: Maintenance and
Troubleshooting
This chapter describes the basic maintenance for your Edge and some examples
of common problems with solutions. There are no user replaceable parts in the
Edge.
Normal Maintenance
Edge
The Edge is a precision measurement device that contains many sensitive
components, and it should be handled with care. Take the following precautions
to prevent problems from developing with your system:
• Place a dust cover over the Edge when not in use.
• Clean with a dry dust cloth. For heavy dirt buildups, use a very small amount
of warm water and gently clean the Edge. Be very careful not to bend the Edge
while cleaning.
• Check the cables for damage to outside insulation, connectors, and pins.
• Do not lubricate the Edge.
The Edge is compensated at FARO’s production facility and should only need to
be recompensated after the unit has been subjected to a shock that removes
surface material or causes bending. Periodic calibration tests should be
completed to certify the Edge accuracy and repeatability. See “Edge
Calibration” on page 76.
FARO recommends you return your Edge to a service center, once a year, for our
annual calibration and a 15 point check up.
Host Computer
The computer is an electronic device containing many sensitive components. It
should be handled with care. Here are some steps you can take to prevent damage
to your system:
• Never use the computer in harsh environments where it may be subjected to
rapid temperature change or excessive dust.
• Never expose the computer to excessive shock or vibration.
08M52E00_FaroArm_Edge.book Page 79 Thursday, October 4, 2012 9:31 AM
To Next Page
Loading...
