FARO Edge
September 2012
27
Chapter 2: Setup
WARNING: Do not disconnect or isolate the ground pin on the power supply
cord.
Select the proper power supply cord intended for installation in a protected
environment. The power supply automatically adjusts to the voltage.
• For 120V Connection: Use a UL Listed, type SJT or SVT, 3-Conductor, 18
A.W.G. power supply cord, terminating in a molded-on plug cap rated 125
VAC, 15A minimum, with a minimum length of six feet.
• For 220 - 240V Connection: Use an international harmonized, 300V rated,
PVC insulated jacket, three conductors of 0.75mm
2
minimum cross-sectional
area, each with a molded-on plug cap marked with proper agency marking for
the country where it will be used.
N
OTE: Power surges, spikes, feedback, and fluctuation in the power source
will affect the equipment and its electronic accessories. Please have your
power source inspected by a professional to provide the cleanest power
source possible.
FARO recommends you allow the Edge to warm-up for at least 30 minutes
before using. For optimum performance, allow the Edge to warm-up for 60
minutes before using.
Edge Battery Pack
Your Edge may be powered using the supplied battery pack. Install the battery
pack to power your Edge when you are not near a grounded power outlet. On the
front side of the base, open the fold-down touch screen controller to access the
battery pack slot.
N
OTE: It is not necessary to install the battery pack if the Edge is connected to
a grounded power outlet.
08M52E00_FaroArm_Edge.book Page 27 Thursday, October 4, 2012 9:31 AM
To Next Page
Loading...
