Faro Edge - Display; Sound; Language

FARO Edge
September 2012
153
Chapter 7: Software
• Touch the NEXT button.
• Select a network connection from the list and touch the NEXT button. If
you selected Static IP, enter the IP address, Subnet Mask, and Gateway.
and touch the NEXT button.
• Type in the network password and touch the NEXT button.
• Touch the HOME button to return to the MAIN menu.
OR
• Touch the WiFi to PC/Laptop button to use the Edge as a network access
point.
• Touch the OK button.
• Touch the HOME button to return to the MAIN menu.
For details on the setup of your wireless connection, see “FARO Wireless -
WLAN” on page 44.
4 Connect the Edge on the network to the FaroArm driver. See “FARO Ethernet
Setup” on page 49.
N
OTE: If the WiFi is enabled, the Bluetooth automatically disables.
Display
Use this command to set the options for the screen in the Fold-Down Touch
Screen Controller. See “Fold-Down Touch Screen Controller” on page 25.
• Transitions - Enable or Disable screen transitions, or fades, between menu
screens.
• Touch the BACK button to return to the SETTINGS menu, or the HOME
button to return to the MAIN menu.
Sound
Use this command to enable or disable the speaker in the Edge.
• Touch to select or clear the SOUND button.
• Touch the BACK button to return to the SETTINGS menu, or the HOME
button to return to the MAIN menu.
Language
Use this command to switch the Edge software language.
• Choose a Language.
08M52E00_FaroArm_Edge.book Page 153 Thursday, October 4, 2012 9:31 AM