Faro Edge - Stability; Convert Units; Calculator; Event Log

FARO Edge
September 2012
157
Chapter 7: Software
Stability
Use this command to view the ambient temperature change of the Edge over a
five minute period of time.
• Notice the ambient temperature for the Edge. Check that ambient temperature
is not fluctuating more than 3°C (5.4°F) over a five minute period.
• Touch the BACK button to return to the DIAGNOSTICS menu, or the HOME
button to return to the MAIN menu.
Convert Units
Use this command to convert a value from one unit to another.
1 Touch DIAGNOSTICS > CONVERT UNITS.
2 Touch a unit group:
• Length
•Angle
• Temperature
3 Type in a value and touch the units in the left column.
4 Touch a unit in the right and view the value in the new units.
5 Touch the BACK button to return to the DIAGNOSTICS menu, or the HOME
button to return to the MAIN menu.
Calculator
Use this command to open a standard calculator.
1 Touch DIAGNOSTICS > CALCULATOR.
2 Touch the BACK button to return to the DIAGNOSTICS menu, or the HOME
button to return to the MAIN menu.
Event Log
Use this command to generate a report of hardware system events. Save this
report to an external location.
1 Touch a location for the file:
•SD RAM Card
•USB Drive
2 Touch the BACK button to return to the DIAGNOSTICS menu, or the HOME
button to return to the MAIN menu.
N
OTE: Only use this command when instructed by FARO Customer Service.
08M52E00_FaroArm_Edge.book Page 157 Thursday, October 4, 2012 9:31 AM