Faro Edge - Change Probe; Hole Compensation; Sphere Compensation; Hardware Configuration

FARO Edge
September 2012
170
Chapter 8: Configuring the FARO Edge in CAM2 Measure
Change Probe
From the DEVICE CONTROL panel, click the PROBE MANAGEMENT button to
show the C
OMPENSATION dialog box. For more information, see “Probes” on
page 178.
Hole Compensation
From the DEVICE CONTROL panel, click the PROBE COMPENSATION POINT
button to compensate the probe. For more information, see “Hole Compensation
Method” on page 185.
Sphere Compensation
From the DEVICE CONTROL panel, click the PROBE COMPENSATION
SPHERE button to compensate the probe. For more information, see “Sphere
Compensation Method” on page 187.
Hardware Configuration
From the DEVICE CONTROL panel, click the HARDWARE CONFIGURATION
button to change the setup of the Edge. For more information, see “Hardware
Configuration” on page 178.
Diagnostics
From the DEVICE CONTROL panel, click the DIAGNOSTICS button to show the
Edge D
IAGNOSTICS dialog box. For more information, see “Diagnostics” on
page 190.
Temperature
From the DEVICE CONTROL panel, click the TEMPERATURE button to show the
T
EMPERATURE dialog box. For more information, see “Temperature” on
page 190.
Measurement Mode Setting
From the DEVICE CONTROL panel, click the MEASUREMENT MODE
SETTING button to set the default collection mode in the M
ODE drop-down
window of the M
EASUREMENT WINDOW for this device.
08M52E00_FaroArm_Edge.book Page 170 Thursday, October 4, 2012 9:31 AM