FARO Edge
September 2012
163
Chapter 7: Software
Compensation Log
The COMPENSATION LOG screen displays the compensation history of the current
probe.
1 Select any compensation to see the differences to other existing
compensations.
• The X, Y, Z values are the location of the center of the ball probe in the last
joint coordinate system.
• The 2 Sigma value is the deviation of all the points taken during the
compensation.
• The Max. Error column displays the displacement of the point with the
largest displacement. In order to pass compensation, this value has to be less
than the single point accuracy specification of the Edge.
2 Touch the SET ACTIVE button to set any selected compensation to active, or
touch DELETE to delete it.
3 Touch the BACK button to return to the COMPENSATION menu, or the
HOME button to return to the MAIN menu.
MADE IN
WLAN
Volumetric:Single Point:
Contains FCC ID: ED9LMX9838
and IC: 1520A-LMX9838
FCC ID: YQM14000
and IC: 9265A-14000
This product is protected by US Patents:
5402582, 5611147, 5794356, 6366831, 6606539, 6904691, 6925722, 6935036, 6973734, 6988322,
7032321, 7043847, 7051450, 7069664, 7269910, D607350.
Other US and worldwide patents issued and pending.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FARO
Model 14000
0.029 mm +/- .041 mm
08M52E00_FaroArm_Edge.book Page 163 Thursday, October 4, 2012 9:31 AM
To Next Page
Loading...
