Faro Edge - Power Issues

FARO Edge
September 2012
84
Chapter 6: Maintenance and Troubleshooting
• Make sure that the compensation hole, cone or sphere is located about ⅔ the
distance of the Edge from the base.
• Make sure that the compensation cone, or sphere, is securely screwed into
the holder and that the holder is securely fastened to a stable surface.
• Make sure that probe tip is in contact with hole, cone or sphere.
• Compensate the probe again, and check that all points were digitized
properly.
• Use the other compensation method (sphere or hole).
Buttons (FRONT & BACK) will not respond.
• Make sure that all of the encoders are referenced. See “Referencing the
Encoders” on page 38.
• Turn auxiliary port OFF. See “Edit Probe” on page 180.
• Check buttons in Diagnostic command. See “Diagnostics” on page 190.
Single-point calibration shows excessive error.
• You must use a ball probe. Check that it is installed correctly. See “Installing
Probes” on page 53.
• Recompensate probe. See “Compensate Probe” on page 181.
• During the test, watch the probe to ensure flush seating in the hole. See
“Edge Calibration” on page 76.
Power Issues
If the Edge is receiving power from the power source, or outlet, but not powering
up the system, the source of this issue may lie in one or all of the following areas:
• Ensure you are using the correct cables.
• Check the cables and connectors for bent pins or damage and ensure that the
connectors are secure. Replace all cables that show signs of damage.
• Check the power source (outlet) for proper voltage, current and grounding. For
more information, see “Edge Power Supply” on page 26.
• Check the power supply for physical impacts or damage. DO NOT use a
damaged power supply.
• Check functionality of the Edge. Look for error codes or operation issues.
N
OTE: Power surges, spikes, feedback, and fluctuation in the power source
will affect the equipment and its electronic accessories. Have you power
source inspected by a professional to provide the cleanest power source
possible.
08M52E00_FaroArm_Edge.book Page 84 Thursday, October 4, 2012 9:31 AM