FARO Edge
September 2012
18
Chapter 2: Setup
4 Tighten the base collar using the attached handles.
For more information see “Mounting Stiffness Test” on page 80 and “Edge
Performance Verification Checklist” on page 89.
Surface Mount Plate Dimensions
The Surface Mount Plate is used to clamp or bolt the Edge to a stable mounting
surface. It is an assembly of a standard 3½” mounting ring and a FARO-designed
base plate.
Figure 2-7 Mounting the Edge
08M52E00_FaroArm_Edge.book Page 18 Thursday, October 4, 2012 9:31 AM
To Next Page
Loading...
